Vance Jack Plate JPL4400 Adjustable 4'' Outboard Boat Jack Plate

Description

Attn: There are chinese counterfeit products that are shipping from Kentucky and elsewhere at this time on ebay posing to be the JPL4400, JPL4500, JPL4000 Etc… The counterfeit products are not eligible for return and have no warranty.
Genuine Vance Manufacturing products only ship from Taft, TN USA and are eligible for returns and warranty and are high quality USA made products. Message us if you have any questions.
To know if the product is new Genuine OEM the seller will be vancemfg and the item location is Taft, TN. Please Message us if you have any questions.
Why a Jack Plate?
A jack plate will compensate for a long shaft engine!
Does Your Boat Need a Jack plate? For this one, we consulted our network of industry professionals. Their responses were all varying degrees of a resounding YES. But how can you tell if your boat would benefit from a jack plate? What are some of the symptoms?
Poor Holeshot
Your outboard’s not perpendicular (straight up & down) in relation to the water at top speed.
If you can trim the engine all the way up without the prop letting go or with no appreciable loss of water pressure at full throttle.
The hull doesn’t seem to “lift” like it should.
Boats rigged with jack plates, but otherwise identical to yours, turn higher-pitch props and perform better
Keep in mind that these characteristics can also be indications of other, more serious problems, but if you’re experiencing any or all of the above, your boat could be a good candidate for a jackplate implant.
Review from 2006 Bass & Walleye Boats Magazine
Product Specifications
Single Adjusting Jack Plate
Made of high strength polished Aircraft Quality Aluminum
Bronze and Brass hardware eliminate binding
Adjusts easily by turning one steel bolt
Offers 4 inches of adjustable Vertical movement
4 inches of setback
Weighs 24 lbs
225 Maximum Horsepower
1 Year Unconditional Warranty against manufacturer defects
Mounting hardware is sold separately, we sell it on ebay here:
https://www.ebay.com/itm/2-50-Inch-Length-1-2-inch-diameter-Jack-Plate-Stainless-Steel-Bolt-Kit-Vance-MFG/303150725179
Jack Plates are the perfect solution for long shaft engines with a short shaft transom! The engine side holes of the Jack Plate are drilled 1.500 inches higher than the transom side. Combined with the 4 inches of adjustable vertical lift you can obtain 5.500 inches at a maximum height to raise your long shaft engine and make it workable on a short shaft transom boat!
Here are the pre-drilled hole dimensions listed below in inches:
Pre-drilled holes for 1/2” stainless hardware
12 7/8” across the top two holes from center to center
9 7/8” across the bottom two holes from center to center
8” of vertical distance between the top holes and bottom mounting holes
If your holes do not match this configuration, you can drill into the aluminum plate. However, by modifying the unit returns will not be accepted.
We manufacture all of our Jack Plates on our own equipment at our facility in Taft, TN USA!
Visit the Vance Manufacturing Website to see all of our products!
If you have any questions please feel free to email or call us, we want to help you. If we are not here or the line is busy, leave a message with your contact information and we will get back with you as soon as possible!